Dear friends, today ’s tutorial is about this noble and vivid little goldfish nail art ,It also involves knowledge of extended& 3D nail art. Come and have a look !
We will use these tools and supplies in this tutorial, goldfish stickers, red paper trays, and plastic clips.
Step 1: After preparing the basic tools, we will first make basic manicure for the nails. After the basic manicure is completed, first apply a layer of primer to the nails. After drying, take out the special paper holder for extension nails. Place the paper holder in the seam of the nail, then attach it, and fix the shape of the nail surface on the nail. Remember that the arc of the paper holder should be almost the same as the nail surface when it is shaped. It cannot be too flat or too curved, otherwise it will not look good. After fixing the paper holder, we started to apply extension gel with the nail brush. When applying the extension gel, we should start from the junction of the nail and the paper holder, and then apply it to the nail bed and the extension part, and finally dry it.
Step 2: Sometimes our nail type may be relatively flat. At this time, we can clamp the plastic clip to the extension part to slightly reshape the nails. After removing the paper holder, we begin to trim the nails. First, Use sand strips for manicure type. When manicure type, please pay attention to align the two sides of the extension part with both sides of this nail. The sponge is used to smooth the nail surface after it is polished, we clean the nail surface with a cleaning brush.
Step 3: After cleaning the nail surface, we will put goldfish stickers on the nails. Of course, if you don’t want to use goldfish stickers, you can also use the golden nail polish to paint on your own. After the goldfish sticker is applied, we use purple nail polish and follow the outline of the goldfish sticker to paint the eyes and body of the goldfish. The body only needs to paint the middle part. After that, we start to draw a long tail, before which let’s dry body and eyes firstly;
Step 4: The tail part can be freely divided into 4-5 pieces. The tail is just a few curves. After everyone finishes, dry it first. Then mix a drop of extension glue with a drop of purple nail polish, and then use a fine brush to apply a thick layer of mixing glue to the fish body, including both sides, so that the fish’s body looks like it has a gradient effect on both sides. A thick layer of mixed glue is also applied between the two tails to make the tail look like a thin film. After drying, we take out the gem glue, which is used for three-dimensional carving and is thicker than extension glue, but is easier to dry than extension glue and suitable for three-dimensional carving. Previously, Jill’s lucky cat was made with it . We dip the gem glue with a pen, and then apply a piece of fish body to make a three-dimensional body, as well as the eyes. Dry each part as soon as it is done, otherwise the colloid may spread out.
Step 5: After the fish’s body is coated with a thick gem glue, we use the same method to coat the fish’s tail, and then dry it. At this point, the goldfish swims on our nails. Finally , we apply a coating to the whole goldfish, and then dry the coating. Our little goldfish is done!
Do you like it? Hurry up and get started.
Pair it with purple pearly luster ~ Is n’t it very aristocratic?